PPM-100 is a handheld power tester for the 
applications of Power over Ethernet (PoE).  It can 
perform the on-site test and measurement of the 
running voltage and the supplying power available for 
the PoE powered device (PD) at the end of Ethernet 
cable terminal in any length. 

In general, a PoE Power Sourcing Equipment (PSE) 
provides the Power over Ethernet to the PD for a 
nominal distance of 100 meters.  In practice, 
however, the power from PSE may fail to meet the 
requirement of the remote PD due to unpredictable 
clues such as the cabling length, the wire connection 
in RJ-45 connector, and the quality of network cable. 

PPM-100 provides for field engineer a convenient on-
site tester to verify PoE, measure the voltage, and 
examine the maximum power from PSE to the PD at the 
end point of the Ethernet cable.

Powered by replaceable and rechargeable battery, the 
portable PPM-100 allows the technical personnel to 
test terminal for PD at any locations. With 3-digit 
LED display, it shows the PoE status and the maximum 
power results of PSE.  With built-in Terminal Block 
connectors, PPM-100 is able to clamp and hold the 
bare wires of network cable for test before clamping 
into the RJ-45 connector. Pass/Fail LED indicators 
may inform technician the results instantly. 

PPM-100 is truly the best handy tool for the 
installation of PD device. The test procedures shall 
successfully guarantee the PoE power provision to PD 
device.

KEY FEATURES

•Measurement of power status from PSE to PD in PoE 
  network
•3-digit LED display showing maximum available power 
  (watt) and running voltage.
•Handheld and Battery-charged tester for on-site PoE 
  status measurement
•Power measurement for standard PSE of IEEE 802.3af 
  and high-power mid-span PSE.
•Support both end-point and mid-span PoE connections.
•Built-in Terminal Block connectors for bare wire 
  clamping to debug RJ-45 wire clamping/connection.
•PSE Isolation and problem debug before connection 
  to PD.
•Pass/Fail Bi-color LED indicators for on-site PoE 
  problem debug or abnormal power status 
•Console port for Firmware Upgrade
•Rechargeable battery pack with power ON/OFF switch
•Battery Low Indicator
•Handy neck belt for holding the device during field 
  test.
•Build-in temperature sensor for overheat protection 
  if high-power load test is applied.